Little Bear Westsail 32 refit: Tiller project Blog #136

Arrrrr me hearties. Welcome aboard.

The tiller on board Little Bear is a beautiful piece of wood. Unfortunately, time & weather have taken their toll. The tiller has actually delaminated.

It would not do to go to sea with a defective tiller, so I take the time to rebuild it and make it strong again.

As always fair winds, following seas, and God bless.

Advertisements
Posted in A Sailor's Life, About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , , | Leave a comment

Little Bear Westsail 32 refit: Cape Horn Windvane pt.2 Blog #134

Arrrrr me hearties. Welcome aboard.

In this session I complete the installation of the hardware for the windvane. And the sun comes out! Yaaay. It’s always a pleasure to see the sun!

I apologize for not getting a better close up of the install I know this would have been of interest to other DIY’ers. But it’s not rocket science and pretty straight forward. I’ll likely do a video of the vane in action once I get it rigged and we’re out there sailing.

As always fair winds, following seas, and God bless.

Posted in About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , , , , | Leave a comment

Little Bear Westsail 32 refit: Cape Horn Windane pt.1 Blog #133

Arrrrr me hearties. Welcome aboard.

With his episode, I get to install a bit of hardware that Little Bear has never had before: a windvane.

I chose Cape Horn Windvane for a few reasons:

  • Price
  • Simplicity of construction
  • Reputation
  • Proven track record

I’ve never sailed with a windvane before but I can see the value of not being glued to a tiller / wheel.  I expect to do a lot of single-handing so being able to roam about the boat without having to tend the tiller seems to be a very good idea.

The Cape Horn also has the ability to integrate an auto-pilot. And because the windvane supplies the power for the tiller a smaller, efficient pilot can be utilized. Bonus.

Installing the windvane was fairly straightforward. However, for the first time during the refit of Little Bear I hurt myself.  I caught the tip of my  finger between a strut and the chuck of my drill. I basically ripped my finger nail off.  In the video you can see the moment it happened.  I dropped the drill but it is tough and suffered no damage.

I have yet to rig the vane with blocks and line but I don’t think that will be a big deal.  I just have to follow the instructions correctly and away I go!

As always fair winds, following seas, and God bless.

Posted in About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , , , , , , , | Leave a comment

Little Bear Westsail 32 refit: Bowsprit Platform on! Blog #132

Arrrrr me hearties. Welcome aboard.

This episode is all about getting the platform installed and aligned. There was a bit if a curve-ball I had to deal with but nothing that liquid joinery didn’t take care of! Oh the wonders of modern technology & chemistry.

The one part of this job that I wish I didn’t have to do was to take off the forestay. But the bowsprit pulpit won’t go back on with the forstay / furler in place. So, off it came.

The biggest challenge was to drill the holes for the support blocks and get them aligned. I explain in the video where you can actually see what I’m describing.

As always fair winds, following seas, and God bless.

Posted in About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , , , , , | Leave a comment

Little Bear Westsail 32 refit: Bowsprit Platform Prep Blog #131

Arrrrr me hearties. Welcome aboard.

After leaving everyone hanging in regards to how I expanded the thru-hull hole, I reveal the mystery of how I did it. A simple enough tactic and it worked very well.

The next project is to get the bowsprit platform mounted on the bowsprit. Without the platform, sail management at the front of the boat would be a very scary proposition. So, the platform must be reinstalled. The teak for the platform was in very rough shape when I took it off. Previous episodes show how I repaired & restored the wood. I’m glad I put the effort into restoring it. Teak is beautiful wood and holds up well in the maritime environment.

The first thing I did was to epoxy the G10 brackets I made into place. They are probably a bit redundant as they are an addition to the sprit that wasn’t there when I bought the boat. But considering that the platform is fairly thin compared to what the plans call for, I feel better having them in place. Stronger is better, in this case.

The sail maker came by while I wasn’t here to measure the boat for sails. This may prove to be an issue later on.

As always fair winds, following seas, and God bless.

Posted in About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , , , , | Leave a comment

Little Bear Westsail 32 refit: Sail Loft Blog #130

Arrrrr me hearties. Welcome aboard.

This episode is the documentation of a trip to the sail loft. Some months ago I contacted about three different lofts asking for quotes for the boat. I asked a high-end loft, North Sails, and a lower end, budget loft for quotes. As I expected, the high-end quote was out of my price-range. Mind you, you get what you pay for and what they offered was definitely in the excellent category. The low end just seemed too sketchy so I decided to go with North Sails. They’ve been around a long time, are a global company and have a good reputation.

So, in this vid, I take my sails into the NS loft for an assessment.

The consultant was reluctant to say any of my sails were junk but I decided to buy new genoa (130%), inner jib / stays’l, and main. It was an interesting visit to be sure.

As always fair winds, following seas, and God bless.

Posted in A Sailor's Life, About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , | Leave a comment

Little Bear Westsail 32 refit: Out with the old! Blog #129

Arrrrr me hearties. Welcome aboard.

This post should have come before the previous post but in a fit of air-headedness, I got them reversed. Ces’t la vie.

I got the old zinc’s off, and I took out the old speed-log through Hull. I tried to remove the thru-hull elegantly and properly but it proved to difficult for culture and class. So, I resorted to a small sledge and smashed it out. 😀 When all else fails, get a bigger hammer.

As always fair winds, following seas, and God bless.

Posted in About Boats, Maintenance, My Boat, Refit, Repair, Tools, Westsail 32, Yacht | Tagged , , , , , , , , , , , , , , , , , , , | Leave a comment